Hello,

I created a cluster successfully now.

On starting slone I get the error:

2005-09-07 14:55:02 ART ERROR  slon_connectdb: PQconnectdb("dbname=contact
host=localhost user=postgres") failed - fe_sendauth: no password supplied

I have password protection on my postgresql servers (I use a web-interface
to connect to the database, so it's necesary to evite that everyone can
login with localhost). Is there any way to setup the password with slony?

Thanks!

Sebastian



----- Original Message ----- 
From: "Alan Hodgson" <ahodgson at simkin.ca>
To: <slony1-general at gborg.postgresql.org>
Sent: Wednesday, September 07, 2005 1:30 PM
Subject: Re: [Slony1-general] Compile


> On Wed, Sep 07, 2005 at 01:00:31PM -0300, Sebastian K?hner wrote:
> > They say:
> >
> > Long and short: This points to a need to "audit" what installations of
> > PostgreSQL and Slony-I you have in place on the machine(s).
Unfortunately,
> > just about any mismatch will cause things not to link up quite right.
> >
> > I don't know what to do. Does anybody know what I could do?
>
> Your installation of Slony probably installed against the wrong version of
> PostgreSQL on your system.  Personally, I would make sure there is only
one
> installation of PostgreSQL on the system, that I knew exactly where it
was, and
> then I would build and install Slony against that.  The libdir that the
slony
> functions need to go into is that same place you'll find plpgsql.so etc.
after
> the PostgreSQL installation.
>
> -- 
> "None are more hopelessly enslaved than those who falsely believe they are
> free." -- Johann W. Von Goethe
>
> _______________________________________________
> Slony1-general mailing list
> Slony1-general at gborg.postgresql.org
> http://gborg.postgresql.org/mailman/listinfo/slony1-general
>